Eminent EM8650 Manual descarregar pdf (Página 3)

3 | ENGLISH

LED indicator :

Flashes continuously : Motion detector is performing a self-test

Flashes 1x : Motion detected

Flashes 2x : Self-test completed. Motion detector is active

Flash once per 3 seconds : Battery power low, exchange battery*

* You will receive a text message if battery level is low. The message contains the

following information (up to sensor 9) Sensor name with additionally the text ‘battery

almost empty’. From sensor 10 the name will be replaced by a zone nr. with

additionally the text ‘battery almost empty’.

3.0 Inside the motion detector

Remove the screw on top of the motion detector and gently remove the front and

back.

3.1 Infrared sensors

The infrared sensors detect the motion. These sensors need to be clean at all time.

Do no touch the sensors !

3.2 Anti sabotage button

If the motion detector is opened this switch will detect it and trigger the alarm.

3.3 LED On/Off

By switching this jumper setting you can set if the LED in front of the motion detector

will be switched “On or Off”. By default this setting is turned ON (LED ON).

3.4 Group settings (jumpers)

Every sensor can be configured to be added to a dedicated group by setting the

jumper settings; home-group, normal group, single group or 24-hours group.

LED On/Off

Infrared sensor

Group setting (jumpers)

Anti sabotage

button

Infrared sensor

1 2 3 4 5 6 7 8

Sem comentários

Eminent EM8650 Manual Página 3